了解 ETO 灭菌器性能：效率的关键
3.4.1 eto sterilizer machine Temperature Setting Range
The temperature setting range for the eto sterilizer is: 30 to 70°C
使用 eto 灭菌器时环氧乙烷泄漏处理
If a leak is detected in the eto sterilizer dosing pipeline during the administration process, immediately close the medication bottle, switch and the dosing valve on the main unit. Turn on the axial fan to ensure proper ventilation, and then proceed with repairs.
使用环氧乙烷灭菌的安全要求
Note: Regardless of whether the equipment is in normal operation, malfunction, or maintenance state, if personnel need to enter the
环氧乙烷灭菌器的微生物杀灭性能
Note 1: The Ethylene Oxide sterilization conditions must be obtained through validation confirmation and should be verified with monitoring and
eto灭菌室温度分布测试
The temperature of representative areas on the inner surfaces should be measured and recorded using temperature recording instruments that comply with the requirements of Appendix B.
eto灭菌前的准备工作
Appearance Inspection: Check the main unit, control rack, and electrical control cabinet for any damage on the surface.
EO灭菌设备及工艺特点模式及效果分析
Start cycle phase(Select parameters/sterilization recipe) Serial number Potentially risky content Risk assessment under existing process conditions Risk assessment of the
ETO灭菌器维护指南
9.1 During ETO Sterilization, operators are not allowed to leave the operating area and must continuously observe the ETO Sterilization process. If any abnormal phenomena occur, the machine must be immediately shut down, and the power supply should be cut off for inspection.
eto气体灭菌的术语和定义
For the purposes of this document, the following terms and definitions apply in ethylene oxide sterilization 3.1 Aeration part of
eo灭菌前的准备工作
Appearance Inspection: Check for any damage on the surfaces of the main machine, control rack, and electrical control cabinet.
Power Supply Check: Ensure the power supply meets the requirements and check the rotation direction of the water pump and vacuum pump.
打开功率并观察仪器显示值是否正常；否则，请在重新启动之前切断电源，检查和维修。
Pipeline Inspection: Check for leaks in the water supply, vacuum, and medication delivery pipelines, and ensure all valves are in standby mode; adjust if necessary.