Author name: Bocon Technical Team

2.1.1 Ukupni oblik treba biti precizan, s glatkim, čistim površinama i ujednačenom bojom. Ne smije biti neravnina, oštrih rubova, pukotina, vidljivih ogrebotina ili neravnina.
2.1.2 Sav vanjski tekst, grafika i simboli moraju biti otisnuti jasno, s preciznim i trajnim oznakama.
2.1.3 Pričvršćivači moraju biti sigurno postavljeni. Svi upravljački prekidači i gumbi (ili gumbi) za podešavanje trebaju raditi glatko i pouzdano bez prepreka.

Within a certain range of gas concentration, the higher the concentration, the better theEO Gas Sterilization effect; beyond 1000 mg/L, the improvement in sterilization effect is not significant.

eto sterilization technologies vs others: Advantages and Disadvantages Sterilization is a critical process in infection control, ensuring that medical instruments

The temperature setting range of the ETO Sterilization Chamber should be between 30-60°C. It is recommended to perform temperature distribution testing of the sterilizer’s internal surface and temperature and humidity distribution testing inside the sterilization chamber to ensure the effectiveness of the heating and humidifying systems.

The purpose of routine monitoring and control of EO (Ethylene Oxide) sterilization is to demonstrate that the confirmed and specified sterilization process has been applied to the product. Data from each sterilization cycle should be recorded and retained to prove that the confirmed sterilization process specifications have been met. This should include at least the following content:

A Process Challenge Device (PCD) is a microbiological challenge system used to evaluate the kill rate of selected process parameters. It is typically a device or test package containing biological indicators (e.g., Bacillus atrophaeus spores with known spore count). The resistance of the PCD to the sterilization process should be greater than or equal to the resistance of the natural microbial load in the most difficult-to-sterilize area of the product. The quantity of PCDs should meet the requirements outlined in Table C.3 of Appendix C in GB18279.1-2015. PCDs are classified into Internal PCDs (IPCD) and External PCDs (EPCD).

Industry Eto Sterilizer Installation Verification The installation of Industry Eto Sterilizer and all associated services should comply with the requirements

The humidification water used in the ETO Sterilization Equipment should be free from contaminants, should not weaken the ETO sterilization process, and should not damage the sterilizer, sterilized products, or the load. Humidification should be done by injecting steam, not by directly injecting atomized water.

Hangzhou Bocon Mechanical and Electrical Equipment Co., Ltd., commonly referred to as HZBOCON, stands out as a dedicated Ethylene Oxide (EO/ETO) sterilizer manufacturer. Established in 2006, HZBOCON has committed itself to the design, development, and manufacturing of EO sterilization equipment, catering to a wide array of industries that require effective sterilization solutions for thermosensitive products.

PQ is the stage of validation that uses Ethylene oxide sterilization chamber to demonstrate that the Ethylene oxide sterilization equipment consistently operates in accordance with predetermined acceptance criteria and the process yields a product that is sterile and meets the specified requirements.